Back to Contents Page

Ultra Small Form Factor

Dell™ OptiPlex™ 760 Service Manual

  Removing the Computer Cover

  Inside Your Computer

  System Board Components

  Dell Badge


CAUTION: Do not place your monitor on the computer. Use a monitor stand.

CAUTION: When setting up your computer, secure all cables toward the back of your work area to prevent the cables from being pulled, tangled, or stepped on.
NOTE: If you want to orient your computer under a desk top or on a wall surface, use the optional wall-mount bracket. To order this bracket, contact Dell (see Contacting Dell).

Removing the Computer Cover

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
  1. Follow the procedures in Working on Your Computer.

  2. If applicable, remove the cable cover, (see Cable Cover (Optional)).

  3. Remove the computer cover:

    1. Rotate the cover release knob in a clockwise direction.

1

release knob

    1. Slide the computer cover forward by 1 cm (½ inch), or until it stops, and then raise the cover.


Inside Your Computer

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: To avoid electrical shock, always unplug your computer from the AC power adapter before removing the cover.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

1

fan shroud/heat sink assembly

2

speaker (optional)

3

memory modules (2)

4

hard drive

5

security cable slot

6

chassis intrusion switch


System Board Components

1

fan connector (FAN_FRONT)

2

internal speaker connector (INT_SPKR)

3

system board speaker (BEEP)

4

channel B memory connector (DIMM_2)

5

channel A memory connector (DIMM_1)

6

SATA data cable connector (SATA0)

7

battery (BATT)

8

password jumper (PSWD)

9

clear CMOS jumper (RTCRST)

10

hard drive fan connector (FAN_HDD)

11

hard drive power connector (SATA_PWR)

12

fan connector (FAN_REAR)

13

intrusion switch connector (INTRUDER)

14 

power light (AUX_Power_LED)

15

processor (CPU)

 

 


Dell Badge

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

The Dell badge on the front of your computer can be rotated. To rotate the badge:

  1. Remove the computer cover (see Removing the Computer Cover).

  2. Pull on the tab away from the chassis and rotate the badge to the desired position.

  3. Ensure that the tab is secured in the slot.

1

release tab in slot

2

slots (2)


Back to Contents Page